![]() Please check and change your configuration if necessary ATTENTION: DHW Push (“Trinkwasser Push”) parameter had to be moved from 1601 to 1603 because 1601 has a different “official” meaning on some heaters.ATTENTION: Check your config if you’re broker relies on the client ID in any way for authorization etc. MQTT: Use MQTTDeviceID as a client ID for the broker, still defaults to BSB-LAN.New value types DT_THMS for time consisting of hour:minutes:seconds Consolidated data and value types: New data types VT_YEAR, VT_DAYMONTH, VT_TIME as subsets of VT_DATETIME for parameters 1-3, replacing VT_SUMMERPERIOD and adjusting VT_VACATIONPROG.New library for DHT22 should provide more reliable results.URL command /JB allows for backing up parameters to JSON file.URL command /JR allows for querying the standard (reset) value of a parameter in JSON format.PPS users can now send time and day of week to heater.HTTP Authentification now uses clear text username and password in configuration.New categories added, subsequent categories have been shifted up.URL commands /A, /B, /T and /JA have been removed as all sensors can now be accessed via parameter numbers 20000 and above as well as (currently) under new category K49.6224!10 to query the identification of the display unit Setting a temporary destination address for querying parameters by adding !x (where x is the destination id), e.g.New MQTT functions, including allowing any parameter to be set by an MQTT message and actively query any parameter once by sending an MQTT message.After that, it will reboot and try to connect again. If BSB-LAN cannot connect to WiFi on ESP32, it will set up its own access point “BSB-LAN” with password “BSB-LPB-PPS-LAN” for 30 minutes.Added MDNS_SUPPORT definement in config so that BSB-LAN can be discovered through mDNS.Older WiFi-via-Serial approach no longer supported. Added better WiFi option for Arduinos through Jiri Bilek’s WiFiSpi library, using an ESP8266-based microcontroller like Wemos D1 mini or LoLin NodeMCU. ![]() Webinterface allows for configuration of most settings without the need to re-flash, also split into basic and extended configuration.Support for special PPS devices (based on DC225/Honeywell MCBA) added.OTA Updates now possible for ESP32-based devices.ESP32 code uses SDK version 2.0.2, please take note when configuring Arduino IDE! Thanks to GitHub user do13, this code now also compiles on a ESP32, tested on NodeMCU-ESP32, Olimex ESP32-POE and Olimex ESP32-EVB boards.ATTENTION: HTTP-Authentication configuration has changed and now uses plain text instead of Base64 encoded strings!.ATTENTION: Folder locations and filenames have been adjusted for easier installation! If you update your installation, please take note that the configuration is now in BSB_LAN_config.h (LAN in caps), and no longer in BSB_lan_config.h (lower-caps “lan”). ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |